How to store plasterboard?
How to store plasterboard?
Good store his plasterboard
- The plasterboard must be stored flat, not on edge, and above all not be leaning against a wall.
- They must be stored on a flat surface, for example on the ground.
- Finally, the plasterboard should be kept indoors, away from moisture.
Is the plaster porous?
the plaster is a good thermal insulator. Porousit absorbs and releases moisture from the air very quickly but degrades in damp places.
How to wear a BA13 plate?
It takes it carry vertically, that’s all. It is especially cumbersome and we type easily. The delicate point is the transport on the roof. I strongly recommend 2 bastaing on the gallery rather than the BA13 placed directly on the gallery.
How is the placo placed?
Rails and uprights: installation of the framework of a partition in placo. Each rail is drilled every 50 to 60 cm with a 6 mm concrete drill. 6 mm knock-in dowels are used for their installation. We start with to pose the rails by fixing them to the ceiling and to the floor.
What is plaster?
Plaster is a pulverulent mixture prepared, since ancient times, from the calcination of gypsum, a sedimentary rock gathered in enormous masses of evaporites, formerly called plaster stone or plaster stone which is sometimes found in the form of alabaster or selenite crystals.
How to make plaster?
The stone is usually quarried from underground mines or quarries and then fired and then broken, crushed and ground to give the white powder of plaster. the calcination of gypsum, to obtain (micro)crystalline materials by heating and sometimes severe dehydration reactions the reduction into fine powders by grinding.
How to get rid of plaster?
Using a mat, place the first cardboard plate, then spread the plaster using three outlets. The plaster is previously mixed with water in a mixer and its temperature is maintained at 70°C. The second cardboard is then placed and the plate is left to dry.
How to dry the plaster?
The cast obviously takes your anatomy into account. The plaster is applied: it will dry slowly. You should not touch the plaster while it dries so as not to create compression. It takes a day and a night for the plaster to dry if it is plaster and four hours if it is resin.
